This is my second full-size, rideable, 3d printed surfboard.  Design goals: Artistic, Drainable, Functional.

The first lamination did not go as expected so now I’m trying to figure out a good way to get more fiberglass on the board.  The first lamination had small holes that I thought would create problems if I tried to use a more traditional method of lamination, with a squeegee for example.  I opted to go with Sheldrake’s paintbrush method again but using a UV Cure resin that will let me take my time to get everything right before setting off the cure.

The process I used is illustrated in the video.  All told I’m pretty happy with the results.  I think I could have done this whole lamination and fins in one day with full-sun.

Notes:

UV Resin is freaking awesome, I didn’t have to rush and it looks fantastic.  Only problem was having to wait for a good sunny day with low wind. (and time off from work)

On the last board, overworking the brush aerated the resin and caused a milky finish. This time I tried not to wipe the brush on the edge of the cup or go over the same area too often and the finish was far better.

If I pressed too hard on the brush, some epoxy would squeeze through the first lamination and pool just under the surface which was disheartening.  I had to be conscious of how I held the brush the entire time, one slip and there was no coming back.  Luckily I only have a few ‘bad’ spots this time around.

After curing the fiberglass lamination until it was firm, I applied a sanding coat with a squeegee and cured that layer before trimming off the excess.  This resulted in a thicker lap line but also saved me from having to re-tape the board.  Technically I don’t need to apply another coat after doing this but I can still feel some texture from the fiberglass.  I’m thinking it may leak a bit…

For the second side, I sanded down the previous lap line and put the new lap line as far as I could up the rail without being on the bottom to get the most overlap.

Ultimately, the finish is wavy as heck and there is no way to sand it with a electric sander without creating more problems.  Since I don’t expect great performance from this board I’m just going to go with the flow.  It looks great as it is and I put a vent in the bottom and holes throughout the design to drain any water that may leak in.  Just need to slap on some fins and add the leash retention pad.